Points You Must Keep in Mind About VicRoads Test Guide

Driving safely may not be enough to pass the VicRoads driving test. Since the officers of the driving license testing will be looking into the series of performing the task, you must drive according to the criteria of the test that you have learnt from the experienced instructors in your driving classes. It’s a good practice to think about the traffic conditions and try to avoid rush hour times that could lead to accidents in heavy traffic. This is also very important for your driving test preparation. However, take a look at the following driving test points that will help you pass the VicRoads driving test in Epping. Make sure to keep these points in mind and avoid common mistakes.

Rolling stops

One of the common mistakes you should avoid is to make incomplete stops. There are many drivers who slow down but didn’t stop completely during the road test. You should avoid doing this as you must come to a full stop and be behind the line of demarcation.

Improper lane changing

It’s not difficult to signal your intention to change lanes. You need to check your mirrors and blind spot before you do so. Unfortunately, people fail to do it all the time. Make sure to change lanes properly. First, you need to turn on your signal, then check the rearview and side mirrors, and also your blind spot, and only when it’s clear, you should change lanes.

Lack of steering control

Although getting confident behind the wheel is important during your test, you shouldn’t be overconfident that you drive one-handed. The driving schools in Epping recommend keeping both hands always on the steering to ensure safety.

Distracted driving

You should keep your stereo and phone off during your driving test. You need to focus on your test and keep your mind on the road.

Driving too slowly

During your VicRoads test, you must show confidence. You must avoid being overly careful and drive below the speed limit as it can cause unsafe conditions for both yourself and other drivers.

Driving too fast

You must stay within the speed limit. Also, you need to be aware of drops in the speed limit, especially in work zones, school zones and other specific speed limit areas.

Braking too hard

You should be familiar with the brakes in your car you will be using for the test in terms of how soft or hard they are. In case of emergencies, hard braking is acceptable, but while stopping or slowing down, you need to use only the brake to get the job done. But, remember, you need to press the brakes not so hard that you and your passenger go forward.

Hope, you came to know the points that will help you pass the VicRoads test. If you like this article, don’t forget to share it with your friends, and get back to us for more exciting content!

Author’s Bio — The author is an owner of a driving school in Epping, and is an avid blogger.